Forum Replies Created
-
AuthorPosts
-
I had a good look at the photos of the interior and it looks like its had a hard life. Damp, doors warping etc.
Dougie
Barry,
£20 sent with much thanks for the efforts you put into this site.
Dougie
Thanks Barry and Co – mines in the post!
Dougie
No thank you Barry for all your much valued time and input on this awesome site.
Dougie.
You may have noticed in the photos I have fitted an additional armrest to the driver’s seat, passenger side still to do later this week. (Thanks for the idea Chris!)
Dougie
Forgot to add that the offset base is 160mm from table edge to the edge of base. If you do this conversion secure with a couple of small screws to make sure it swings around without touching the wall. Mine just clears it with this measurement. That way you can reposition it until you find the right position then secure permanently.
I am not sure if will work on the SK version as I don’t know if there is enough room in front of the bench seat.
Table and leg removed back to original, just the brackets visible.
Twin dining with easy access to central aisle.
Stowed away to the side but can still be used
Or this way if you prefer
Table in place for 2
Step 2 leg clamp fitted above base plate and leg put into place. Table base plate fitted offset to underside of table. Trial and error to get best position for pivot swing.
Step 1 Base plate fitted in the corner
Hi Chris,
I have just fitted the additional drivers armrest from Marcle Leisure, as you say not too difficult at all. So much more comfortable for those motorway miles so thank you for sharing your upgrade.
Now onto the passenger side armrest for the other half – keep her sweet!
Dougie
-
AuthorPosts